Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

A36 specification for warpage and bow

Status
Not open for further replies.

TGLewis

Industrial
Jun 22, 2007
3
I'm trying to spec a flame cut part that is 22.5 feet long and 1.5 inches thick, A36. The supplier asks me what tolerance I expect for warpage and bow of the raw material, are they not the same thing?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor