sebastia0
Mechanical
- May 2, 2012
- 1
Hello, I started working with Abaqus for a short time, and I'm trying to validate a study (stress analysis, not the failure analysis), based on the following article
I've done the model, but when i choose the non-linear geometry in step and run the job, abaqus gives me an error "Time increment required is less than the minimum specified". I've run the program several times differently and i can not understand why the results are not correct.
I've done the model, but when i choose the non-linear geometry in step and run the job, abaqus gives me an error "Time increment required is less than the minimum specified". I've run the program several times differently and i can not understand why the results are not correct.