Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Abaqus error message

Status
Not open for further replies.

abc123ali

Mechanical
Nov 6, 2023
90
Respected users, I am facing two errors continuously ""too many attempts needed to complete this step and the ""increment required is less than the minimum specified"". When I adjust anyone of the two the two alternative erros comes again and again.
Thanks
 
Replies continue below

Recommended for you

Those are typical non-convergence errors, changing those numbers almost never helps. You have to find a cause of convergence issues. It can be contact, material behavior or other phenomena, it's impossible to say without examining the model.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor