Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ABAQUS/Explicit: Anti-aliasing filter minimum output intervals

Status
Not open for further replies.

ShadowWarrior

Civil/Environmental
Joined
Aug 21, 2006
Messages
171
Location
AU
So I checked on Anti-aliasing filter in history and field output request, and the following warning message pops up -

The number interval used on *field, output, filter=antialiasing may be too small to construct an acceptable cutoff frequency for filtering. The cutoff frequency of this filter was changed to a higher value, corresponding to a time frequency of 200 field frames.

Is there any guideline about the minimum number of intervals requested? For example, the Default in History output request is 200, and Field output request is 20 (for evenly spaced time intervals).

I had requested 100 intervals in my analysis, see below -

PrtScr_capture_2_uozbxu.jpg
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top