xxh418
Computer
- Jun 6, 2012
- 8
Hi All,
I just did a simple test for job recover feature in ABAQUS/Explicit. I set the interval number for restart output and selected "overlay" opinion.
Then I run simulation for a while and killed the simulation. Then I choose "recover" type in ABAQUS/CAE job editor and resubmit the job.
However, the job aborted very soon after I submitted the job without giving any useful error information. Could someone give me some ideas what is the problem in my setup? Thanks.
Best
Oliver
I just did a simple test for job recover feature in ABAQUS/Explicit. I set the interval number for restart output and selected "overlay" opinion.
Then I run simulation for a while and killed the simulation. Then I choose "recover" type in ABAQUS/CAE job editor and resubmit the job.
However, the job aborted very soon after I submitted the job without giving any useful error information. Could someone give me some ideas what is the problem in my setup? Thanks.
Best
Oliver