Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ABAQUS/standard rank 0 received the SIGABRT signal

Status
Not open for further replies.
Emre SENGUL

Emre SENGUL

Mechanical
Jan 24, 2019
30
When I am running my model in Abaqus, I took 'ABAQUS/standard rank 0 received the SIGABRT signal' error in different time step in every running job. What is the reason of it? Could you tell me the reason of it, please?

Note: I took solutions for different load directions with the same model.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Check the msg and dat files. They may contain additional errors that are more specific.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

nilesh_dot
  • Locked
  • Question
Problem during linking - Abaqus/Standard User Subroutines
Replies
2
Views
501
nilesh_dot
nilesh_dot
E
  • Question
ABAQUS IS NOT RUNNING THE MODEL
Replies
3
Views
3K
FEA way
FEA way
IcarusAero223
  • Question
XFEM in Abaqus/Standard for 3D CFRP layup - nodal level set value error
Replies
9
Views
2K
FEA way
FEA way
N
  • Question
ABAQUS FASTENER
Replies
1
Views
1K
FEA way
FEA way
MPa94
  • Locked
  • Question
Fully coupled thermal-stress analysis in Abaqus/Standard- equations
Replies
8
Views
305
FEA way
FEA way

Part and Inventory Search

Sponsor

Back
Top Bottom