Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Abaqus: Update part in assembly

Status
Not open for further replies.

DKEngineer

Student
Apr 3, 2023
20
DK
Hi,

In assembly module I am using the "Create instances" and "merge/cut instances" tool to partition a part using a shell part as partitioning geometry.
This works fine. But when i edit one of the original parts in the part module, the assembly doesnt change corresponding to the edited part. Is there any way to do this?
 
Replies continue below

Recommended for you

This method creates a new part that is not linked to the original parts. You would have to use Merge/cut instances again to create a new part with those changes.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top