cchngtn
Mechanical
- Aug 15, 2001
- 9
Dear respected Engineer,
I have to design four pad eye at the container design.
However, I found that if directly mount/ weld the Padeye at the corner post, there will cause the hollow beam to deform.
How to design the padeye at corner post? The container has to pass the test at 35tonnes?
Thank!
I have to design four pad eye at the container design.
However, I found that if directly mount/ weld the Padeye at the corner post, there will cause the hollow beam to deform.
How to design the padeye at corner post? The container has to pass the test at 35tonnes?
Thank!