Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ACME Thread per inch???????????

Status
Not open for further replies.

Guest
I need to know where I can find a general TPI value for an acme screw with 3/8 inch diameter
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Acme 3/8" thread is 12 TPI
Don
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

maquina01
  • Locked
  • Question
Doubt about 3/4 14 DRYSEAL NPSF THREAD 1
Replies
1
Views
47
Tmoose
Tmoose
PeterKing
  • Locked
  • Question
thread too tight
Replies
2
Views
221
unclesyd
unclesyd
Senselessticker
  • Locked
  • Question
Cost per fixture of 3 lamp vs. 4 lamp fluorescent type
Replies
2
Views
86
fishon
fishon
bigmark1972
  • Locked
  • Question
What is the highest tensile threaded rod available?
Replies
2
Views
59
metengr
metengr
mitaco
  • Locked
  • Question
What diffrent between PT, NPT and FPT thread 5
Replies
1
Views
596
mizkn
mizkn

Part and Inventory Search

Sponsor

Back
Top Bottom