Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
Acme Threads on Web anywhere?
- Thread starter sprintcar
- Start date
Acme thread info, dimensions, etc. Trying to match an existing part but its not in Mach Handbook. Maj Dia is about 6 7/16"
0theblacksmith0
Structural
Try some of these results
Best of luck-TWWeld.
Best of luck-TWWeld.
the od of the thread means very little in dimensioning. the pitch, lead(if it is multiple start), style of acme, and/or threads per inch will lead you to most of your dimensions.
it is possible to cut a common thread on any given diameter
as long as you are also making the matching nut. this used to be common practice years ago in america's factory thriftier days to save material when repairing stripped shafting threads while saving the rest of the shaft. not too common now days though.
hope this helps,
send me more information and i'll try to help,
bob creely
bcreely@yahoo.com
it is possible to cut a common thread on any given diameter
as long as you are also making the matching nut. this used to be common practice years ago in america's factory thriftier days to save material when repairing stripped shafting threads while saving the rest of the shaft. not too common now days though.
hope this helps,
send me more information and i'll try to help,
bob creely
bcreely@yahoo.com
- Status
Similar threads
- Locked
- Question
- Question
- Locked
- Question