Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

AD7714

Status
Not open for further replies.
GustavoRivas

GustavoRivas

Computer
Jan 18, 2006
1
Hello!!!, i need assistence to use the analog digital converter AD7714, because its use a serial interface i i dont know how to use with the 8051, i can not use Tx and Rx becase i need to comunicate with the PC in serial mode. Thnaks a lot!!!
 
Replies continue below

Recommended for you

Sort by date Sort by votes
This is to large a job for here... I will say you need to read the data sheet for the 7714 and you will need to use indiviual 8051 pins(NOT THE TX and RX pins) to place the correct pattern of voltages on the pins of the 7714.
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom