Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Adams/matlab co-simulation

Thread starter VenkyS1
Start date Feb 8, 2017

Status: Not open for further replies.

Feb 8, 2017

VenkyS1

Mechanical

Hi,

I am trying to do a matlab - adams co simulation. The model built in Adams is perfectly working and am able to get a complete simulation run. When I try to do the same from Matlab (after exporting a Adams control plant and giving necessary inputs from Matlab), the error shows up

WARNING : Edge with no mate found
The shell may not be water tight.

Please help me out with this. Thanks in advance.