VenkyS1
Mechanical
- Aug 1, 2016
- 7
Hi,
I am trying to do a matlab - adams co simulation. The model built in Adams is perfectly working and am able to get a complete simulation run. When I try to do the same from Matlab (after exporting a Adams control plant and giving necessary inputs from Matlab), the error shows up
WARNING : Edge with no mate found
The shell may not be water tight.
Please help me out with this. Thanks in advance.
I am trying to do a matlab - adams co simulation. The model built in Adams is perfectly working and am able to get a complete simulation run. When I try to do the same from Matlab (after exporting a Adams control plant and giving necessary inputs from Matlab), the error shows up
WARNING : Edge with no mate found
The shell may not be water tight.
Please help me out with this. Thanks in advance.
