Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Adaptive bending press brakes

Status
Not open for further replies.

kendalsimon

Industrial
Jan 15, 2010
14
Hello all, hope this is in the right place and that someone can help me out. We currently have 4 Amada press brakes that we use for bending mostly steel, but an increasing amount of copper busbars. The copper is flat bar, up to 200x10mm and I thinking about another press brake with adaptive bending and was wondering if anyone had any experience of the sort that monitor the bend angle either mechanically or with a laser
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor