Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Add vertex to chamfer dimension

Thread starter mdambros
Start date Sep 26, 2012

Status: Not open for further replies.

Sep 26, 2012

mdambros

Mechanical

I have a dimension .004 X 45 degrees created with the CHAMFER DIMENSION command. I used the Callout Perpendicular under the Properties. It pulls a leader off with the chamfer dimension. Is it possible to add a vertex to the leader now? I know you can do it with leaders by using the ALT key while selecting the leader line, but I can't get it to work with the chamfer dimension.

Thanks