loyal979
Mechanical
- Nov 6, 2018
- 47
Hello all,
I am working on modeling two layers of wood bonded together with glue. To model the adhesive/glue layer in Abaqus, there is the cohesive zone method, but this method is intended to investigate failure/damage such as delamination. My goal is to evaluate the the effect of the adhesive layer on the moisture diffusion in wood. So there is no damage analysis in my simulation.
What would be an appropriate method to model the adhesive layer in my simulation?
Thanks
I am working on modeling two layers of wood bonded together with glue. To model the adhesive/glue layer in Abaqus, there is the cohesive zone method, but this method is intended to investigate failure/damage such as delamination. My goal is to evaluate the the effect of the adhesive layer on the moisture diffusion in wood. So there is no damage analysis in my simulation.
What would be an appropriate method to model the adhesive layer in my simulation?
Thanks