Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Advanced simulation / Results / Annotation

Status
Not open for further replies.
HonzaS

HonzaS

Mechanical
Nov 5, 2010
21
0
0
CZ
Hello,

please do you know if it is possible to adjust accuracy (number of digits shown behind decimal point) in the NX postprocessing annotations?

Thanks a lot!
Honza
 
Status
Not open for further replies.

Similar threads

Maxxoru
  • Locked
  • Question
Pin list Annotation
Replies
0
Views
7
Maxxoru
Maxxoru
turbineer
  • Locked
  • Question
SOLVED, NX2206: where's a simple FEA simulation ? 2
Replies
7
Views
49
3DDave
3DDave
Jennifer.S
  • Locked
  • Question
Advanced Weight Management Export to Excel
Replies
0
Views
7
Jennifer.S
Jennifer.S
Bobby4241
  • Locked
  • Question
NX Modal analysis results
Replies
0
Views
6
Bobby4241
Bobby4241
Spyros07
  • Locked
  • Question
FSI Staggered Simulation
Replies
0
Views
2
Spyros07
Spyros07
Back
Top