Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Aermod.inp: I got the same values both PM10 and PM2.5

Status
Not open for further replies.

FOH99

Chemical
Aug 3, 2023
3
Currentely, I'm using "MODELOPT CONC FLAT ELEV BETA" in the aermod.inp. My sfc and pfl files are generated from WRF (using MMIF). I'd like to model the PM10 and PM2.5 in AERMOD. However, when I did tests (using the same emission rate) I got the same values both PM10 and PM2.5. I think could be due to the "CONC" parameter. While we know the PM2.5/PM10 ratio must be less than 1. I would expect to have slightly different values, but not exactly the same. What would be the right MODELOPT configuration to consider the particle size in the horizontal dispersion.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor