Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

After Floworks, can COSMO take the result and give FOS?

Status
Not open for further replies.
phonix

phonix

Military
Jan 27, 2007
54
Can I have Floworks compute the max pressure on each surface, and then do FIA on the result and see deformation and min FOS?
 
Status
Not open for further replies.

Similar threads

IdanPV
  • Locked
  • Question
Create Custom Results Plot in Solidworks
Replies
2
Views
380
IdanPV
IdanPV
oharag11
  • Locked
  • Question
Error - Please enter a value greater than 0 - Thermal Joint?
Replies
0
Views
377
oharag11
oharag11
jacob999
  • Locked
  • Question
COSMOSM
Replies
3
Views
109
3DDave
3DDave
seraph3333
  • Locked
  • Question
IR LED solidworks thermal simulation unexpected extreme low temperature problem
Replies
2
Views
79
seraph3333
seraph3333
Denny Gibson
  • Locked
  • Question
SolidWorks 2018 Simulation: Simultaneous solution of mechanical and thermal stresses?
Replies
1
Views
87
FEA way
FEA way

Part and Inventory Search

Sponsor

Back
Top Bottom