Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Aimed at uk based metallurgists.

Thread starter etch
Start date Aug 2, 2002

Status: Not open for further replies.

Aug 2, 2002

etch

Mechanical

I need some information on tensile testing of LM6, we consistently obtain results that are lower that that stated in alars book of 190 uts 80 proof and 7% elongation.

I need to know is anyone has tested LM6 Chill, and obtained results higher than these?