Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Aligning 2D rectangular shapes in Visio

Thread starter tulrich
Start date Jul 15, 2002

Status: Not open for further replies.

Jul 15, 2002

tulrich

Electrical

We are having problems aligning 2d rectangular shapes in a horizontal fashion on a drawing as we drag them from the stencil to the drawing page. We are wanting the shapes to consistently snap and align at their lower right or left hand corners. However, it seems that regardless of snap and glue settings the shapes do not consistently align properly as you bring a new one on to the page and locate it close to one of the bottom corners.

Any help would be appreciated. Thanks.