Aligning cross section sheets in Geopak

[AJgeo]

I am trying to center cross sections on a 20 scale sheet using
geopak to create the sheets. For some reason geopak keeps placing the sections near the bottom of the sheet, while I would like to keep them in the center. Any suggestions?

 

[namdac]

AJgeo,
Under your sheet run you will need to set your bottom dimension. If you are using V8 look under Margins and Spacing. However if you are using Microstation J or Geopak 2001 Under Cross Section Sheets go to Vert Clear Zone.
Hope this helps.
Regards,
Namdac