Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Allowable stress and deflection for plates in Tension and Compression

Status
Not open for further replies.
Tonywil67

Tonywil67

Marine/Ocean
Jan 24, 2003
1
Please could anyone give me a hint what are the acceptable allowable stresses in tension, shear , compression and also acceptable deflection for thin and thick plates? .

Thanks.

Anthony Wilson.

 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

A
  • Question
Deflection of unbonded multiple steel plates 1
Replies
13
Views
7K
human909
human909
drile007
  • Question
Floor Plan Symbols for Tension and Shear Connectors in Timber/CLT Structural Layouts?
Replies
0
Views
644
drile007
drile007
Struct123ure
  • Question
Curved Beam Roark's Formulas for Stress and Strain
Replies
7
Views
2K
Geoff13
Geoff13
CivilSigma
  • Question
AISC Chapter I - Composite Section: Stress and Strain Distribution in Composite Section 2
Replies
9
Views
8K
JoshPlumSE
JoshPlumSE
reverbz
  • Locked
  • Question
Do Drag transfer connections need to resist tension & compression?
Replies
2
Views
208
lexpatrie
lexpatrie

Part and Inventory Search

Sponsor

Back
Top Bottom