Altivar 61 vfd parameter correlation to Altivar 21

[powersoff]

I am looking for parameters in a Altivar 61 VFD manual that would correspond to parameters 241 and 242 in a Altivar 21 vfd. The Parameter F241 provide a means to stop the drive when the analogue reference signal goes below a certain level and then F242 provides a hysterisis so that when the signal comes back a + your hysterisis, it will restart.

 

[ozmosis]

If you can set the ATV61 up in PI(D) mode then you could use the Sleep function that will perform as you need. But you need PI set within the drive.