AM simulation (FDM) part is not cooling fast enough in heat transfer

[mosta1]

Hi,

I'm doing an FDM simulation and I'm using very simple material model. The problem that the model is not cooling fast enough. If anyone can guide me I will really appreciate it.
I have attached the input file.

Best,
Mostafa

 

[FEA way]

Can you also share the event series files referenced by this input deck ?

 

[mosta1]

Thanks for replying here is the event series file.

 

[FEA way]

At first glance, the results look good. Check the values (especially in terms of units) related to cooling - make sure that they are the desired ones.

 

[Adil Memet]

Hello Mr Mostafa
I tried to your model to test it how it works, could you please share the strcture model as if possible? I'm also interested in AM simulation. thanks