AMADA FO 3015 X+ overtravel (How to reset?)

[RPosty]

I over traveled the X axis, "EMER" is lit up, but no faults in memory and I can't find a procedure to reset it in the Manual. I know it is probably simple, any of you know how to reset it?

As always, Thanks

"I am stuck on Band-Aid brand, 'cause they are stuck on me"

 

[RPosty]

I figured it out. book says:

press "Safety Device Reset" Button turning on the "Safety Device Ready" light. (on our machine this has no affect and ready light is always on).

What we had to do was press and hold center button OT release til flashing red "EMER" stopped, then hit the Programming panel "Reset" button, then Jog the axis.

"I am stuck on Band-Aid brand, 'cause they are stuck on me"

 

[nicknick]

That took me forever to figure out when that first happened . Or when i had the e button pushed on the other side of the machine and could not figure out what was going on.