Passyk
Civil/Environmental
- Feb 22, 2017
- 1
( Sorry for my english, i know, its not 100% )
Hi everyone,
i have question. Im working in small company, we have there some older CNC Laser machine.
And the problem is... I set up all the parameters, and it was good, the holes were clean, nice. contour also. But then i change programe for other work, and when i finish it,
i put there again the programe what was there before, the same programe i didnt change anything, but suddenly it was shit. Burned too much, i cannot use it. And again came a hours of trying, changing, and trying a setting the parametrs etc.
Can somebody help me with it ? I dont know where can be problem.
Can be problem the (we call it head) thing from where the laser coming out ?
Have somebody experience with it ?
Thanks. I will appreciate every advice.
Hi everyone,
i have question. Im working in small company, we have there some older CNC Laser machine.
And the problem is... I set up all the parameters, and it was good, the holes were clean, nice. contour also. But then i change programe for other work, and when i finish it,
i put there again the programe what was there before, the same programe i didnt change anything, but suddenly it was shit. Burned too much, i cannot use it. And again came a hours of trying, changing, and trying a setting the parametrs etc.
Can somebody help me with it ? I dont know where can be problem.
Can be problem the (we call it head) thing from where the laser coming out ?
Have somebody experience with it ?
Thanks. I will appreciate every advice.