Hi all!
I have never used the roller head on my Amada 2415. I normally use the sensor head but my current application of cutting door shapes out of 3/16” HR perf (3/4” holes) requires me keep a set height on the laser head. I haven’t been able to get it to cut correctly. On the settings page there is head type setting 1-5, is there a head type number which corresponds to the roller head? Aside from turning off the sensing head option, which settings do I need to change in order for the machine to adjust to the roller head?
Thanks!
I have never used the roller head on my Amada 2415. I normally use the sensor head but my current application of cutting door shapes out of 3/16” HR perf (3/4” holes) requires me keep a set height on the laser head. I haven’t been able to get it to cut correctly. On the settings page there is head type setting 1-5, is there a head type number which corresponds to the roller head? Aside from turning off the sensing head option, which settings do I need to change in order for the machine to adjust to the roller head?
Thanks!
