Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

An Ortho from a Broken View

Status
Not open for further replies.

diamondcat

Automotive
Aug 21, 2002
238
I have limited MDT(2004DX) experience and I am trying to work with a broken view. I finally figured out how to make the broken view but now I am stuck.

1) How to make an ortho view off of the broken view and have it broken in the same spots and inline.

2) How to add a break line symbol to the broken edges. Right now it is just lines that stop. I tried using the Design/Special Lines/ZigZag line but I cannot select the ends of the lines to put it in.

Thanks
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor