Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

analysis a wood rafter with an opening due to mechanical duct

Status
Not open for further replies.
Sam1993

Sam1993

Structural
Jan 12, 2022
30
Hello All:
Is it possible to analysis a wood rafter with an opening due to mechanical duct in RISA 3D and apply the loads and study the stresses around it

picture are attached for reference and opening marked in red

Capture_neduqd.png
222_lx0uan.jpg


Thank you
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Well, if the opening is as big as you drew, its a pretty simple analysis.

Looks like a VERY bad idea.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

mohamed hassan 2014
  • Locked
  • Question
Nonlinear analysis using HyperMesh with OptiStruct
Replies
0
Views
489
mohamed hassan 2014
mohamed hassan 2014
Stress_Eng
  • Question
FEM Contact Analysis Variables
Replies
17
Views
11K
Stress_Eng
Stress_Eng
vanji1
  • Question
If I want to construct myself a geometric stiffness matrix induced by a pre constraint with finite element modeling
Replies
0
Views
1K
vanji1
vanji1
Facundo L. Pfeffer
  • Locked
  • Question
Correct way to perform nonlinear buckling analysis
Replies
6
Views
820
centondollar
centondollar
AACING
  • Locked
  • Question
Methods to add rotation dof to solid with ABAQUS, MSC NASTRAN and SAMCEF
Replies
3
Views
1K
GVDR
G

Part and Inventory Search

Sponsor

Back
Top Bottom