Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Angle Dimension

Status
Not open for further replies.
ChrisGeof

ChrisGeof

Mechanical
Joined
Jan 26, 2006
Messages
3
Location
CA
Hi!

I have Catia V5 R16 SP1 and when I want to do an angle dimension, instead of a degree symbol, I have a question mark. This happend only in drawing mode, in sketch mode it is ok. What is the problem? Thanks!
 
Sort by date Sort by votes
I would look at your fonts and make sure that there is a degree symbol available in the selected font.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

A
  • Question Question
DRAWING PROJECTION ANGLE CHANGING
Replies
1
Views
4K
jackk
jackk
R
  • Question Question
CATIA V5 Automation creating Dimension
Replies
1
Views
1K
qiushui
qiushui
S
  • Locked
Catia 3D F T & A Get value of Dimension using Macro/Vba Proamming
Replies
0
Views
889
sammehta
S
706Jim
  • Locked
  • Question Question
Catia drafting default dimension change
Replies
3
Views
1K
706Jim
706Jim
Mike90
  • Locked
  • Question Question
How to add brackets to dimension macro
Replies
1
Views
329
rickyt
rickyt

Part and Inventory Search

Sponsor

Back
Top