Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Anhydrous Ammonia Pump (High Pressure)

Thread starter wehber
Start date Nov 16, 2009

Status: Not open for further replies.

Nov 16, 2009

wehber

Mechanical

Hi,

I was wondering if anyone was familiar with a high pressure anhydrous ammonia pump. I am using this for a desuperheat configuration after gasous expansion. I am looking to go from 200 psi suction to 700 psi discharge max with a nominal flow rate of 1.5 GPM. I have looked at various mag-drive pumps but haven’t contacted any vendors yet. I wanted to gauge the communities input first.

Thanks!