Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Animation of sheet metal rolling

Status
Not open for further replies.
Replies continue below

Recommended for you

Typically this is done by varying parameters such that more of the part is on one side of the roller and less on the other and copying the screen at each small step and then using movie/animation software to put the individual images into an animation format.
 
This can be done using a sweep along the path. There can be other ways as well.

Deepak Gupta
SOLIDWORKS Champion and Expert
SW 2022 SP0.0, 2021 SP5.1 and 2020 SP5.0
Boxer's SOLIDWORKS Blog


 
Status
Not open for further replies.

Part and Inventory Search

Sponsor