Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Anode mass - Surface area (DNV-RP-B401)

Status
Not open for further replies.
SiggiN

SiggiN

Marine/Ocean
Mar 18, 2019
33
Hi!

Suppose you have a flange connection as shown below

Would you exclude the surface area of the bolts on the "inside" of the bolt holes, when calculating required anode mass?

Is such an exclusion supported by DNV-RP-B401?

Anode_Bolts_sfsioh.png


Regards
Siggi
 
Status
Not open for further replies.

Similar threads

b_unruhly
  • Locked
  • Question
Expected Surface Rougness of a Zn Phosphate treatment on a machined steel bar.
Replies
7
Views
3K
MintJulep
M
rmain
  • Locked
  • Question
Surface oxidation on Aluminum Alloy & electrical continuity
Replies
8
Views
680
Gr8blu
Gr8blu
awesomeness
  • Locked
  • Question
Cathodic protection with Al-Zn-In anodes of carbon steel / 316L
Replies
3
Views
452
awesomeness
awesomeness
montbIanc
  • Locked
  • Question
Marine sacrificial anodes - Clarification of design criteria
Replies
4
Views
568
FacEngrPE
FacEngrPE
T2ioTD
  • Locked
  • Question
Are anodes always wired back to the steel in the case of passive cathodic protection? 4
Replies
9
Views
474
LittleInch
LittleInch

Part and Inventory Search

Sponsor

Back
Top Bottom