Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in

ANSI Standard for pneumatic plumbing of shot pins.

Status
Not open for further replies.
dtwo

dtwo

Automotive
Oct 17, 2002
137
0
0
US
We have an application where we are using a shot pin (driven by an air cylinder) to fix a rotating trunnion while performing maintenance. Does anyone know if there is a safety standard that outlines the safest way to plumb the pneumatic circuit?
 
Status
Not open for further replies.

Similar threads

Tmoose
  • Locked
  • Question
ANSI Standard tolerances - B4.1 - but not just cylindrical fits
Replies
0
Views
11
Tmoose
Tmoose
ShlomoB
  • Locked
  • Question
Adding the same balloon multiple times in a drawing (ANSI) 1
Replies
3
Views
12
ewh
ewh
Nathan Gardner
  • Locked
  • Question
how to show Pneumatic diagram with options
Replies
0
Views
11
Nathan Gardner
Nathan Gardner
Mauro Nicoli
  • Locked
  • Question
ANSI 16.5 1
Replies
6
Views
13
Mauro Nicoli
Mauro Nicoli
Quality Improvement 1
  • Locked
  • Question
ANSI Standard requiring changing part number vs revision 1
Replies
3
Views
22
looslib
looslib
Back
Top