I'm applying a remote compressive displacement to a plate that sits on top of a rubber spring (z-axis). At the moment I've constrained the x and y displacement to zero - which is not representative. Nor is allowing the plate to move freely in the x and y direction. How do I allow the plate to move freely in the positive and negative x and y directions up to a specific value as the compressive displacement is applied?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
Ansys 12.1 - Remote Displacement
- Thread starter prelmes
- Start date
Similar threads
- Locked
- Question
- Locked
- Question