Ansys Adams Interface

[tomiad]

Hello erverybody,

I want to use the Ansys-Adams interface but I don't know how to do this.
I have used Workbench until now. Does this interface work with Workbench or only with APDL?
Is there a book or a website with quite good tutorials on this topic?

Thank you

 

[bagarbilla]

i think that interface is only available in ANSYS classic.. but u can use APDL command in workbech to apply loads exported by ADAMS .. if u want to export flexbody data to adams then as i know u have to use ANSYS classic ..