Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ansys additive error

Status
Not open for further replies.

Ahmed_abdelgawad

Mechanical
May 30, 2023
8
Hi,
I am currently trying to simuate 3D printing using Ansys WB.
after setup the model i get
"the time to apply the heat is greater than the time to cool down the layer. this indicates a units problem or inconsistent input values. check your material properties, part size, mesh height, etc"
Knowing that the same setting worked previously.
your help is much appreciated.
Thanks in advance.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor