Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ansys batch mode

Status
Not open for further replies.

skjoex

Structural
Joined
Jul 17, 2007
Messages
82
Location
SK
Hi,

i have been using (...learning) ansys for two years, but just now i realized that there is another way to run input file.
i studied ansys manual, but in my opinion there are too little information about this issue.

1. Can anyone give me some pros/cons of using ansys batch mode ?

2. Are there some restrictions/differencies in writting input file for batch mode compare writting it for GUI ?

3. how to say ansys not terminate executing of imput file in batch mode when encounters the first error ? i tried to use /nerr,0 - but it didnt work - may be i didnt fully understand to help file relative to this command because of my english.

4. another hints/tips/net sites relative to using ansys batch mode are appreciated.

PS: i had to change my nick from skjoe to skjoex because of problems with login.

Regards,
lubo
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top