ANSYS close down itself

[lwf]

I am trying to run ANSYS using macros. after building the model and applying the loads/constrains, I run ANSYS using code

SOLVE
FINISH

/POST1, PLNSOL, S, EQV

PLDISP, 2
/DSCALE, 1, 0
/EOF
ANSYS automatically closes down without error message. Do you know what could be the reason? the memory overflow? Thanks.

The log file is as follows:

/COM,ANSYS RELEASE 10.0A1 UP20060105 13:57:50 09/18/2007
/input,menust,tmp,'',,,,,,,,,,,,,,,,1
/GRA,POWER
/GST,ON
/PLO,INFO,3
/GRO,CURL,ON
/CPLANE,1
/REPLOT,RESIZE
WPSTYLE,,,,,,,,0

 

[Stringmaker]

The /EOF command is intended to be used when nesting files. When using the /INPUT command there is a LINE argument which allows you to read only a segment of a file. This segment is identified by a label which starts with a colon, :, and the /EOF command is intended to be used as a flag to mark the end of the segment. Even typing /EOF in the GUI will cause normal termination of Ansys. If you wanted to only use a portion of a file consider calling it from a parent file and it should function normally when containing the /EOF command.