Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ansys coupled EMAG-structural

Thread starter Evila
Start date Jan 19, 2012

Status: Not open for further replies.

Jan 19, 2012

Evila

Bioengineer

Hi everyone. I am trying to couple a magnetostatic analysis in ANsys to a structural. What I want is to use the calculated body force densities from the magnetostatic analysis into a structural. The manual says that there is a compatitbility between these two modules but I cant make the connection. I have attached a photo of what I am trying to do. Any suggestions?
Thanks!