Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ANSYS Crack Tip Meshing

Thread starter vigneshv9
Start date Jul 9, 2012

Status: Not open for further replies.

Jul 9, 2012

vigneshv9

Structural

Hi,

I am trying to insert a crack in a model using the macro CTMOPT in Ansys 13.
It is a surface crack, full crack. I get an error claiming 'Please check the workplane orientation and crack dimensions'

Anyone has solutions/tutorial for proper use of this macro?

Thanks!
vigneshv9@gmail.com