Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

ANSYS fauilre criteria APDL

Thread starter Ahmedarhman
Start date Sep 19, 2017

Status: Not open for further replies.

Sep 19, 2017

Ahmedarhman

Structural

I'am working with ANSYS 9.00 for modiling concrte girder using solid65. I want to provide a failure criteria to use maximum strain value. and the crosponding results at this value at the postprocess stage. could you please provide an example or information about the procedures.
thank you
regards,
Ahmed