Actually, i am new to the software and i am trying to learn. So i was actually following some tutorial available on the internet. But when it came to the Fluent (Set-up) stage, i found out that the window does not display any picture. Is there any solution for this proble,?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
ANSYS FLUENT Display Problem
- Thread starter Rolandky
- Start date
Similar threads
- Locked
- Question