Z2EC_Mech
Structural
- Apr 16, 2021
- 1
Dear Forum Users,
I have a very simple question. I am studying the stresses of a semi-ellipsoidal head in an axisymmetric analysis. The model runs fine. However, I am unable to use a cylindrical coordinate system in the solution branch after I transformed this coordinate system (e.g. rotated the x-axis 90 degrees). I do the transformation as the default placement of the coordinate system is not to my liking. I am only able to use the cylindrical coordinate system in the solution branch if I use the default settings. Any offset or transformation operation results in not being able to select this coordinate system in the solution branch (e.g. stress -> normal stress > coordinate system -> Cylindrical, is not able to be selected). Does anyone know why this occurs and how to resolve it? Thanks in advance.
regards,
Z2EC.
I have a very simple question. I am studying the stresses of a semi-ellipsoidal head in an axisymmetric analysis. The model runs fine. However, I am unable to use a cylindrical coordinate system in the solution branch after I transformed this coordinate system (e.g. rotated the x-axis 90 degrees). I do the transformation as the default placement of the coordinate system is not to my liking. I am only able to use the cylindrical coordinate system in the solution branch if I use the default settings. Any offset or transformation operation results in not being able to select this coordinate system in the solution branch (e.g. stress -> normal stress > coordinate system -> Cylindrical, is not able to be selected). Does anyone know why this occurs and how to resolve it? Thanks in advance.
regards,
Z2EC.