Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ansys Modelling

Thread starter Ceaserlee
Start date Dec 3, 2003

Status: Not open for further replies.

Dec 3, 2003

Ceaserlee

Mechanical

hi, i'm trying to analyze a water filled cup using shell51 as the rough analyze and shell63 as the fine analyze. i'm having a problem trying to extract the stress value of the cup analyzed. can anyone pls give me a hand ?

and as the shell63 is analyzed in 3D, can please show me how to apply load and constraint on the testing? is that i have to apply the loads and constrains before i extrude it into 3D or i can apply it after the extrude ?

thank you for helping ...