Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ansys Parametric doesn't make the loop

Thread starter Znjmech
Start date Nov 18, 2017

Status: Not open for further replies.

Nov 18, 2017

Znjmech

Mechanical

Hi All

I have a simple question , when I choose a variable in my structural model to make it parametric, in Workbench, I see that the arrow only exists from the step and goes to the parametric but doesn't return to the step, I just want to create a set of results varying the quantities of a variable in a range, witohut optimization. how is this possible to do ?