Acreeet
Mechanical
- Aug 26, 2011
- 15
Hi Every body,
I'm having a slight problem opening & getting started with my analysis in ANSYS Workbench v11. Whenever I start it, I do not get the right prompt, i.e the prompt shown in the picture attached. I can only open a new project. I'm pretty sure, it's not a licensing issue as i had the person in charge of installing it to check the license & he agreed it was ok.
I'm trying to import a parasolid file into ANSYS & carry out some thermal analysis but can't even find the import option within the project interface.
Any help would be much appreciated.
I'm having a slight problem opening & getting started with my analysis in ANSYS Workbench v11. Whenever I start it, I do not get the right prompt, i.e the prompt shown in the picture attached. I can only open a new project. I'm pretty sure, it's not a licensing issue as i had the person in charge of installing it to check the license & he agreed it was ok.
I'm trying to import a parasolid file into ANSYS & carry out some thermal analysis but can't even find the import option within the project interface.
Any help would be much appreciated.