Hello
In the help system for Ansys Workbench 11, it says that you can now attach surfaces from Inventor models - I'm fairly sure that at release 10 this couldn't be done at all.
The above statement may well be true, but I cannot for the life of me figure out how to generate a 2D surface model in Inventor. If possible, I should like to be able to do this by projecting the plane created by a cut through a 3D axisymmetric model, for analysis in 2D.
Any pointers would be greatly appreciated.
Thanks.
In the help system for Ansys Workbench 11, it says that you can now attach surfaces from Inventor models - I'm fairly sure that at release 10 this couldn't be done at all.
The above statement may well be true, but I cannot for the life of me figure out how to generate a 2D surface model in Inventor. If possible, I should like to be able to do this by projecting the plane created by a cut through a 3D axisymmetric model, for analysis in 2D.
Any pointers would be greatly appreciated.
Thanks.