kamcio326
Mechanical
- Jan 17, 2016
- 4
Hi everybody,
I'm new in this forum and I've trivial problem in Ansys Workbench. I want to apply force to the center of the hole to simulate pulling a rod which is connected to joint. Earlier I've worked with Abaqus and there I was using reference point which was tied with cylindrical surface of hole. Now I have to do the same in Ansys and I've no idea how to do this.
Thank you in advance.
Kamil
I'm new in this forum and I've trivial problem in Ansys Workbench. I want to apply force to the center of the hole to simulate pulling a rod which is connected to joint. Earlier I've worked with Abaqus and there I was using reference point which was tied with cylindrical surface of hole. Now I have to do the same in Ansys and I've no idea how to do this.
Thank you in advance.
Kamil
